Page 61 of 61

Re: New Program - GSAK (Geocaching Swiss Army Knife)

Posted: 26 June 16 8:47 pm
by tronador
Ok so may have to contact Clyde

Re: New Program - GSAK (Geocaching Swiss Army Knife)

Posted: 26 June 16 9:58 pm
by allrounder
Both issues are covered on the GSAK forum

Re: New Program - GSAK (Geocaching Swiss Army Knife)

Posted: 26 June 16 10:00 pm
by tronador
Ok thank you. Ilk take a look.

Re: New Program - GSAK (Geocaching Swiss Army Knife)

Posted: 27 June 16 4:02 pm
by Tuena
I had a look as have had similar problems in the past & a week ago the macro stopped working all together - no error messages just had enough. I changed my PQs to limited States & updated GSAK manually on my newer Win 7 laptop (never10). Thought I'd run it again on the old laptop so could relate where it stopped running & lo & behold it's working again, apart from catching GCA Queries.

When checking the GSAK home page it says GSAK only runs on Win 7 & above but my old clanker is Vista.

If I was to update to GSAK V8 is there a macro that would capture both GCA & GC caches?

Re: New Program - GSAK (Geocaching Swiss Army Knife)

Posted: 27 June 16 5:07 pm
by allrounder
there's three macros for downloading GCA caches...you could wrap one of those with a macro that downloads GC caches...you'd be better off posting your request in the GSAK forum...

Re: New Program - GSAK (Geocaching Swiss Army Knife)

Posted: 17 December 17 7:19 am
by Now_To_Morrow
A question from a Facebook page (I know nothing about GSAK):

"OK - I give up! How do you load a GCA Query into GSAK, or even just one cache?
I clicked on GPX files in the Downloads section, but then when I click on the GPX file that has been downloaded it does not open in GSAK.
I also created a Query, but can't work out how to load it into GSAK."

Re: New Program - GSAK (Geocaching Swiss Army Knife)

Posted: 17 December 17 8:39 am
by CraigRat
gsak.net has all the info.

There is a query macro written that can grab your GCA queries there.
GC query grabbing is also built in to GSAK.

Re: New Program - GSAK (Geocaching Swiss Army Knife)

Posted: 17 December 17 9:57 am
by J_&_J
Here's the GSAK forum thread for the LoadGCAQueries.gsk macro: http://gsak.net/board/index.php?s=f2065 ... ntry178848

This macro, when used in GSAK will open a list of all the queries that either you personally have created here on GCA, or public queries listed here. You then tick the queries you wish to load and it downloads them for you and merges them into your GSAK database.

Re: New Program - GSAK (Geocaching Swiss Army Knife)

Posted: 14 March 18 1:46 pm
by The Morris
I am unable to run the gcarefresh macro as it asks me to check username and password, which I did. Is this a result of the change or do I need to try harder?

Re: New Program - GSAK (Geocaching Swiss Army Knife)

Posted: 14 March 18 4:06 pm
by CraigRat
The change of our URL from http to https is the probable cause, you might need to contact the mtrax to fix (we've caused him a few headaches this week!) OR pull it apart yourself and replace any occurances of http://geocaching.com.au to https://geocaching.com.au

I did it with my copy and it works fine